Smartthings create new smartapp4/30/2023 ![]() The DIY version of the SmartApp (discussed above) does not have this issue as it is associated to SmartThings OAuth implementation. I am getting the error "Client is not associated with a SmartApp in location". You can find more information about it in this support article. It also doesn't show under the Initial State account settings like the official version. This version is not officially supported and is much more manual in the setup and installation process. It does not do any buffering and sends events right as they happen. We've published a DIY version of the SmartApp that removes the OAuth integration and allows the user to change whatever they'd like and publish the SmartApp for themselves. Ok, I'm an advanced/curious user and the integration keeps stopping. Go to the bottom and send a screenshot of the information starting at Application State going to the bottom of the window.Go to the bottom and select the "Initial State Event Streamer" SmartApp link.Go to the bottom and select "List SmartApps".If multiple locations are associated with your account, select the location you're debugging.Log in with your SmartThings credentials if prompted.To get this information, follow these steps: If you can't get your connection up and running, you can send us some information to help you debug your SmartThings SmartApp. ![]() Sending Troubleshooting Data to Initial State If you have any issues with this, please contact us. Select the bucket you were previously using and you should be good to go! The dropdown box is a list of your bucket names and, to the right of the name, the "bucket key". When you click on the name, it turns into an editable dropdown box. If this happens, you can simply re-configure the SmartApp integration by uninstalling and re-installing the SmartApp integration with these instructions:Ĥ) After some events have occurred for the selected devices/capabilities on your SmartThings network, you will start to see them showing up in your Initial State SmartThings Bucket.Īdditionally, if you want the data to go to the previously created SmartThings bucket, you can simply change the bucket that the SmartApp is configured to use by clicking on the name of the bucket inside the SmartThings configuration tile in your Initial State account. Sometimes, although extremely rarely, the SmartApp integration may stop sending events. My SmartThings events were streaming to my bucket, but they've now stopped, how do I get it started again? ![]() This means you're guaranteed to get all the events that happened in 15 min intervals or sooner if you have more frequent events on your SmartThings network. So, the integration only sends events after 10 events have been collected or 15 mins has passed, whichever occurs first. SmartThings requests that apps with high traffic like ours buffer requests before sending them. I connected SmartThings and a bucket was created but there is no data, where is it? The SmartApp should create a bucket as soon as it's configured from your account and if it doesn't it will try again once it sends the first payload of events (after 10 events have occurred or 15 min has passed since the integration was enabled, whichever happens first). I've connected SmartThings following the tutorial, but I don't see a bucket created, what do I do?įirst, try waiting a few minutes or triggering a some events in your SmartThings home network like turning lights on and off. For the rare scenario when the SmartThings integration isn't automagical, here are a few troubleshooting steps to consider:
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |